The Patchbay Blog

On Aug 29, 2017, at 12:23 PM, Frank LoCrasto wrote:
Hi Mister Patchbay,

I've got an ADC QCP 96 pt tt punch patchbay. On the back panel of the patch bay, the top row from left to right is numbered 1, 49, 2, 50, 3, 51 and so forth. The bottom row from left to right is numbered 25, 73, 26, 74, 27, 75 and so forth. My question is does the back panel mirror the front exactly? Does "1" correspond to the upper left input on the front of the patchbay and "25" on the lower left input? Or is "49" the lower left input on the front of the patchbay?

thanks!
fRaNk
--
http://www.franklocrasto.com/
franklocrasto.bandcamp.com


Hey Frank,

Channel one is upper left. Channel 49 is under that channel being the first channel bottom left. The reason they are setup that way is if you want to set the normals, you only need to punch a wire from #1 to #49 right next to it etc.

96 Point Patchbays:
To make Full Normal wire from Blue #1 to Blue #49 ; wire from Blue #2 to Blue #50
From Orange #1 to Orange #49; From Orange #2 to Orange #50 etc.

To make Half Normal wire from Red #1 to Blue #49
From Black #1 to Orange #49; wire from Red #2 to Blue #50 From Black #2 to Orange #50 etc.


http://www.misterpatchbay.com/patchbays/movies-how-to-wire-your-patchbay.html

Sincerely,
Bobby Hickey
817-926-9535
Visit Bob Land Below
Mr. Patchbay Website: http://www.misterpatchbay.com/
Mix resume: http://www.misterpatchbay.com/patchbays/mixing-resume.html
GaugeCraft: http://www.gaugecraft.com/
March 2018
October 2017
September 2017
August 2017
April 2017
February 2017
January 2017
September 2016
May 2016
April 2016
December 2015
October 2015
August 2015
March 2015
November 2014
June 2014
May 2014
March 2014
February 2014
January 2014
December 2013
November 2013
June 2013
March 2013
February 2013
December 2012
September 2012
June 2012
May 2012
October 2011
July 2011
June 2011
April 2011